Dimplex Duo400N Provozní pokyny

ContactDetailsPleasenotethatsomeofthecontactdetailsonthisPDFdocumentmaynotbecurrent.Pleaseusethefollowingdetailsif

- 9 -15Carefully fi t the bottom row of the back layer of energy retention cells, placing the two end cells in position fi rst with the fl at side towa

- 10 -19In its factory default setting, the radiant element will be allowed to operate for up to 2 hours after the beginning of the off peak charge pe

- 11 - IMPORTANTThe wires in the direct acting supply cable are coloured in accordance with the following code:GREEN & YELLOW: EARTHBLUE: NEUTR

- 12 -This appliance complies with the European Standards EN60335-2-30, EN 60 335-1, EN 60 335-2-61, EN 61000-3-2, EN 61000-3-3, EN 55014 and EN55104

- 1 -Dimplex DuoHeat RadiatorModels: Duo300i, Duo400i and Duo500iInstallation Instructions85702 Issue 12THESE INSTRUCTIONS SHOULD BE READ CAREFUL

- 2 -Energy Retention CellsEnergy retention cells are supplied separately to the radiator in packs of two.The reference number is 85743.Duo300i8 Cells

- 3 -Circuit Diagram

- 4 -INSTALLATION OF THE RADIATORTurn the carton upside down and open the carton from the bottom. Remove the feet from the polystyrene corner support

- 5 -6Stand the radiator on its feet and against a wall. Remove the securing screws along the bottom edge of the front panel. 7 Swing bottom of pa

- 6 -The following must be applied before fixing the radiator to the wall:NO SKIRTING BOARD / SKIRTING BOARD NO TALLER THAN 100MM 11A The radiator is

- 7 -12B Place the 30mm spacer to the outside of the radiator and the 10mm to the inside Fig. 12B. Drill the holes as detailed in Section 11. Caref

- 8 -13Remove the inner front panel by removing the screws along its top edge Fig. 13A. Carefully lift the bottom of the front inner panel out of the