Dimplex QM070 Provozní pokyny

- 1 -A world of expertiseInstallation InstructionsIMPORTANT These instructions should be read carefully and retained for future use. Note also the inf

- 10 -Building the Heater Core10. Remove the inner front to gain access to the core of the heater. Lay the inner front carefully to one side to ensur

- 11 -BricksThe bricks are supplied separately to the heater in packs of three.The reference number is 047243.12. The bricks have several grooves on

- 12 -14. The third row of brick is positioned in a manner similar to the fi rst row. Again be careful not to damage or dislodge the element.15. Fit

- 13 -Fig. 1717. Close the core by refi tting the inner front panel complete with insulation. Ensure the bottom edge is located inside the chassis an

- 14 -IMPORTANTDuring the initial operation some odour may be noticed due to the newness of materials used in manufacture. This is normal and will dis

- 15 -Circuit DiagramINDICATES ORANGE WIREINDICATES WHITE WIREFILTERFANACNNLACLFAN RESISTORROOMTHERMISTORPCBUSERINTERFACEBLACKROOMREDFANWHITECOREELEME

- 16 -

- 2 -IMPORTANT WARNING - THE SURFACE OF THIS HEATER CAN BE HOT.WARNING - THIS APPLIANCE MUST BE EARTHED.• The installation must be carried out by a s

- 3 - We recommend that a guard is fi tted around the heater, as is normal with some types of heating appliances in similar circumstances. A range of

- 4 -Preparation 1. Place the heater fl at on the ground with arrows printed on the base of the carton pointing upwards.Open the carton at the bottom,

- 5 -3. Ensure the heater is stable before removing the screws which hold the grille panel in position. Set the grille to one side.4. Remove the tw

- 6 -Installing the Heater The heater must be securely fi xed to a wall. Screws with suitable wall fi xings for solid walls are provided. If other wal

- 7 -Fig. 6Fig. 76. Place the heater in its fi nal position and mark the fi xing holes through the location holes visible through the back of the heate

- 8 -Electrical Connections8. The heater leaves the factory confi gured to operate with two mains supplies, a 24 hour supply and an off peak switched

- 9 -9. The mains cable entry bushes and terminal blocks will be visible on the right hand side of the unit. Insert the mains cables through the cab